MD Series Model 4-MD Magnetically driven pump for mildly corrosive chemicals and solutions. The MD Series features leakproof, seal-less magnetic drives and are designed for in-line, non-submersed use. Thermally protected open fan-cooled motor with ball bearings. 6 ft. power cord and 3-prong molded plug. (230V version has no plug). Specific Gravity – up to 1.1′ Ambient Air Temperature – up to 77F (25C). Fluid Temperature Up to 150F (66C). Product Specifications Spec Sheet Item Number: 582002 Model Number: 4-MD

Performance – Models range up to 100 gallons per minute at 5′ of lift. Switch – Tethered style non-mercury float switch operates in sump diameters of 14″ or larger. Intake – Screened intake prevents debris from entering the pump. Oil-Cooled Motor – Transfer heat to sump water efficiently while lubricating internal motor components.

Water WizardSubmersible Pumps Includes garden hose adapter and removable inlet screen for easy cleaning. Lifetime oil supply. Pumps down to 1/8″ (3.2 mm.), in manual mode operation. 1200 GPH @ 1′ maximum flow rate 1/6 HP thermally protected, shaded pole motor Epoxy-coated cast aluminum housing 1″ FNPT outlet includes garden-hose adapter Bottom inlet has removable screen for easy cleaning Switch On at 7 3/8″ (18.7cm) Switch Off at 3/4″ (1.9cm) Product Specifications Spec Sheet Item Number: 505025 Model Number: 5-MSP

Submersible Pump 1/6 HP made by Afras RS100 10101 Electrical specification: 115 VAC, single phase, 60 hz. Pump is supplied with three wires cord. Water Temperature Range: Max. 90F. Operation Position: Vertical. Pump should always be electrically grounded I to a suitable electrical ground. Know the pump application, limitations, power requirements and potential hazards. Install a circuit Breaker. Do not leave pump unattended! If the pump has been operating satisfactory and the discharge flow suddenly stops, stop the pump Do not operate the pump without water l around pump suction. Drain all water from system before servicing. All wiring and electrical work should be done by qualified electrician. Secure the discharge line before starting pump Unsecured discharge line may cause injury. Do not install or use in explosive atmospheres. This pump is designed to pump only water and not intended for pumping any other liquids. Pump motor is equipped with an automatic reset thermal protector and may start unexpectedly. If flexible discharge hose is used, make sure pump is secured in position to prevent movement. Failure to do so could cause piping to break, pump to fail, etc. Which could result in property damage and/or personal injury. Always disconnect the
…read more