Jandy Salt Water Gen. APURE1400 Flow Sensor R0403700 Threaded 8′ Cord.

20A Fuse Holder Hayward Goldline GLX-FUSE-20 The kit includes: Fuse Holder—————-1 1/2 Washer—————-1 20A Slo-Blo Fuses——–2

Goldline Salt Water Chlorinator Logic Main Circuit Board GLX-PCB-MAIN Used on all models, all datecodes

IntelliChlor Dummy Bypass Spacer Cell made by Pentair 520588 For a newly plastered swimming pool use a spacer cell (P/N 520588) for 30 days to ensure all swimming pool debris has been filtered out, avoiding damage to the IntelliChlor.

Jandy Salt Water Gen. APURE1400 Control Box Decal Top R0404300

Goldline Salt Water Chlorine Generator Aqua Rite Turbo Cell T-CELL-3 The Turbo Cells automatically generate a self-renewing supply of fresh, pure chlorine for water that’s clean, clear and luxuriously soft. T-CELL-3 is for swimming pools up to 15,000 gallon swimming pools. Servicing and Cleaning the Aqua Rite cell Turn off power to the Aqua Rite before removing the electrolytic cell. Once removed, look inside the cell and inspect for scale formation (light colored crusty or flaky deposits) on the plates and for any debris which has passed through the filter and caught on the plates. If no deposits are visible, reinstall. If deposits are seen, use a high pressure garden hose and try to flush the scale off. If this is not successful, use a plastic or wood tool (do not use metal as this will scratch the coating off the plates) and scrape deposits off of plates. Note that a buildup on the cell indicates that there is an unusually high calcium level in the swimming pool (old swimming pool water is usually the cause). If this is not corrected, you may to have to periodically clean the cell. The simplest way to avoid this is to bring the
…read more

Hayward Salt Chlorinator Aqua Rite Main Board GLX-PCB-RITE NEW MENU SETTING REQUIRED! Because this replacement mainboard is used to replace various models, it must be configured to operate your swimming pools Turbo Cell before operation. After installing the board, refer to the steps below to correctly configure the board for use with the installed Turbo Cell. Failure to perform this step may result in inaccurate salt readings, improper operation, and possible system shut- down. Determine the model of the installed Turbo Cell which can be found on its colored label. Refer to the following information and steps below to set the Turbo Cell type. “t-3” = T-CELL-3, GLX-CELL-3-W “t-5” = GLX-CELL-5, GLX-CELL-5-W “t-9 = T-CELL-9, GLX-CELL-9-W “t-15” = T-CELL-15, GLX-CELL-15-W Slide the l/lain Switch to the “Auto” position. Push the Diagnostic button repeatedly until “t-xx” appears on the display (“t-15” is the factory default). lf the desired cell type is displayed skip to step 4. To change to a different cell type, slide the lVlain Switch from “Auto” to “Super Chlorinate” and back to “Auto”. Repeat this process until the desired cell type is dis played. Push the Diagnostic button to exit. The GLX-PCB-RITE has now been configured and is
…read more

Electrode for Jandy AquaPure Ei 35 Salt Water Chlorine Generator R0511400

Pentair Salt Chlorinator IntelliChlor Cell Acid Washing Kit 520670 Includes: Closed-end union cap (1), O-ring (1), Coupling nut (1)

Apure 1400 700 Sswimming pool Piece made by Jandy R0412800 R0412800 is discontinued! Replacement part number is SP3PLX