6 in. Trap for Sta-Rite Max-E-Glas Dura-Glas Pump C253-58P R38004 6″ Trap Body No longer available!

Impeller for Sta-Rite Max-E-Glas Dura-Glas 1.5 HP Pump C105-137PDBA

Gasket for Sta-Rite Max-E-Glas Dura-Glas Pump C20-123 V26-359

DURA-GLAS and MAX-E-GLAS CENTRIFUGAL PUMPS with TRAP Failure to pump Reduced capacity or discharge pressure Suction leaks/lost prime: Pump must be primed; make sure that pump volute and trap are full of water. Make sure there are no leaks in suction piping. Make sure suction pipe inlet is well below the water level to prevent pump from sucking air. If suction trap gasket is defective, replace it. Suction lift of 15 to 25 feet (4.5 to 7.5 meters) will reduce performance. Suction lift of more than 25 feet (7.5 meters) will prevent pumping and cause pump to lose prime. In either case, move pump closure (vertically) to water source. Make sure suction pipe is large enough. Clogged pipe/trap/impeller, worn impeller: Make sure suction trap is not clogged; if it is, clean trap and strainer. Make sure impeller is not clogged, check impeller for clogging Impeller and diffuser may be worn. If so, order replacement parts from Repair Parts List Pump may be trying to push too high a column of water. If so, a “higher head” pump is needed. Electrical: Pump may be running too slowly; check voltage at motor terminals and at meter while pump is running. If low,
…read more

Diffuser for Sta-Rite Max-E-Glas Dura-Glas 3/4-2 HP Full Rated Pump C1-200PA V26-367 CMP purt number is 25356-100-000

Lid Opener for Sta-Rite Max-E-Glas Dura-Glas Pump U79-11

Seal Plate for Sta-Rite Max-E-Glas Dura-Glas Pump C203-193P The kit also includes shaft the seal and the seal plate o-ring.

Diffuser O-ring for Sta-Rite Max-E-Glas Dura-Glas Pump U9-226 V26-368

Lid for Sta-Rite Max-E-Glas Dura-Glas Pump 16920-0011 V26-363 6" Trap

Seal Plate O-Ring for Sta-Rite Max-E-Glas Dura-Glas Pump U9-228 V26-354