Power-Flo II Seal with Cup PS-2131 made by U.S. Seal SPX1500KA INSTALLATION INSTRUCTIONS FOR REPLACEMENT SEALS Disassemble pump cavity to expose defective seal. Removal of old seal and installation of new seal requires careful operations and precautions. CAUTION: Lapped and polished faces of new seal are easily scratched and damaged. PROTECT FROM DAMAGE, DIRT and FINGER PRINTS. Carefully remove old seal head and seat taking care not to scratch shalt or seat counterbore. NOTE HOW OLD SEAL IS ASSEIVIBLED. BE SURE REPLACE MENT SEAL IS INSTALLED IN IDENTICAL MANNER. Clean shaft and counterbore surfaces using fine emery cloth or equivalent Remove rust, burrs, and wipe clean. Shaft, seat counterbore and rubber members of seal head and seat should be lubricated with a lubricant compatible with the seal elastomers. U.S SEALUBE is recommended and available from US Seal. U.S. SEALUBE is a WATER BASED formula specifically designed to lubricate rubber making the installation of mechanical seals fast and easy. It provides a high degree of lubricity to all rubber components. It maintains its wetness for a short period of time allowing for easy installation of a mechanical seal. NEVER use PTFE or SILICONE based lubricants. Check seal surfaces to be sure
…read more

Power-Flo II Housing O-Ring Gasket made by Hayward SPX1705Z1

Power-Flo II Impeller 1/2 HP made by Hayward SPX1705C

Power-Flo II Impeller 3/4 HP made by Hayward SPX1707C

Power-Flo II Impeller 1 HP made by Hayward SPX1711C

Power-Flo II Strainer Housing with Basket made by Hayward SPX1500CAP

Power-Flo II Strainer Cover with O-Ring made by Hayward SPX1500D2A

Power-Flo II Strainer Cover O-Ring made by Hayward SPX1500P

Power-Flo II Strainer Basket made by Hayward SPX1250RA Used on models 1992 and prior.

Power-Flo II Housing made by Hayward SPX1705AA