Pentair 20 AMP DPST Relay Kit RLYLX

January 24, 2013 in Pool and Spa Control Parts by PoolSpaRemote


Pentair 20 AMP DPST Relay Kit RLYLX

Relay Kit for 20 AMP DPST made by Pentair RLYLX

Application:

A 20 Amp DPST Relay used to activate 230V or 115VAC equipment (pumps, lights, etc.) from auxiliary control circuits on Pentair Pool ProductsControl Systems.

Specifications:

TYPE DPST
MAX AMPS 20
PUMP HP MAX 2
LIGHTS MAX 1000 WATTS, 500 PER POLE
CONNECTOR BLOCK EACH SCREW ACCEPTS TWO 12-GAUGE WIRES

Installation:

  1. Remove cover panel from right-side compartment of Power Center to expose high voltage section.
  2. Remove wingnut from mounting stud of Relay Kit, and position relay below existing relays.
  3. Loosen LOCK SCREW of hinged faceplate (left-side compartment), and swing it open to expose low voltage section. Feed low voltage connector through lower hole, and mounting stud through upper hole in compartment divider.
  4. Plug low voltage connector into appropriate relay socket on circuit board, located behind hinged faceplate.
  5. Snap terminal block into appropriate position on mounting track in high voltage section. Push hard to secure.
  6. Make appropriate LINE and LOAD connections to terminal block.

No Comments »