.American Eagle Pump Diagram

TROUBLESHOOTING

Failure to Pump

1. Pump will not prime – too much air.
   Check suction piping and valve glands on any
   suction gate valves. Secure lid on pump strainer
   pot and make sure lid gasket is in place. Check
   water level to make sure skimmer is not drawing air.
2. Pump will not prime – too little water.
   Make sure suction lines, pump strainer, and pump
   volute are full of water. Make sure valve on
   suction line is working and open (some systems
   do not have valves). Check water level to make
   sure water is available through skimmer.
3. Pump strainer clogged.
   Clean pump strainer pot.
4. Pump strainer gasket defective.
   Replace gasket.

Reduced Capacity and/or Head

1. Air pockets or leaks in suction line.
   Check suction piping and valve glands on any
   suction gate valves. Secure lid on pump strainer
   pot and make sure lid gasket is in place. Check
   water level to make sure skimmer is not drawing air.
2. Clogged impeller.
   Remove, clean and adjust.
3. Pump strainer clogged.
   Clean suction trap.

1	39200200	Lid, clear
2	39204100	O-ring
3	39200100	Basket
4	39201700	Integral pot & volute, 2″ suction port
4a	39201100	Volute, booster
5	98206400	Plug, 1/4″ with O-ring
6	39200300	O-ring, volute
7	39204600	Reinforcing ring, S/S
8	39204800	Gasket
9	39204700	Diffuser
10	39200600	Impeller, 3/4 HP
	39200700	Impeller, 1 HP
	39200800	Impeller, 1-1/2 HP
	39200900	Impeller, 2 HP
11	39702000	Seal 1000
12	39201000	Seal Plate
13	98203400	Bolt, hex, 3/8 – 16 x 3/4″
14	98210300	Washer, Flat, 3/8″
15	98216200	Bolt, hex, 3/8 – 16 x 1-1/4″
16	37413000	Nut
17	39201300	Support, motor
18	98203000	Screw 13-16 x 3/4″ high-low
19	37413000	Nut, hex 3/8-16, volute to seal plate