Jandy Heater Hi-Limit Switch 135F R0022700 Used on the following models: DK, DM,DR 125 THRU 400 EC,EG,ES 125 THRU 400 PC-||,ES-|| 125 THRU 400 ESG,ESC 125 THRU 400

LXi LRZE LRZM Heater 3 in. Coupling Nut Kit with O-Rings made by Jandy R0454000 Used on the following heaters: LXi Low NOx 250 ⇒ 400 Legacy LRZE 125 ⇒ 400 Legacy LRZM 125 ⇒ 400

Jandy Heater Ignitor R0317200 Used on the following models: LLD (NAT & LP)

Jandy Heater Air Pressure Switch R0302000 Used on the following models: EHE 220-350 HJ350 LX/LT 250-400 RSH 250-400 The images (click images to enlarge them) below give information for replacing the air pressure switch on all LX/LT, rsh, and Hi-E2 EHE and HJ model swimming pool/spa heaters. All RSH and Hi-E2 HJ heaters present a simple like for like replacement and should not need detailed instructions. Later models (built in 2004 or later) of the LX and LT and the Hi-e2 EHE also present a simple like for like replacement and should not need detailed instructions. Although it appears different, the pressure switch enclosed in this kit is functionally the same as the pressure switch on the earlier models of LX and LT and the Hi-E2 EHE. These models will require some modification in order to mount the pressure switch as explained in the following instructions (click images to enlarge them). Page 1 Page 2 Page 3 Page 4

Jandy Heater Flame Sensor LD R0334300 FLAME SENSE RECTIFICATION REPLACEMENT KIT. Used on the following models: Lite2 LJ all Lite2 LD, LG all

High-Limit Switch Disc made by Jandy R0023200 36T01 22323 L135-15F E00722 A0920 36T01 22322 L150-30F E00639 A0907 Used on the following models: DH, DK, DM, DR 125-400 EG, EC 125-400 EPC, EPC-II 125-400 EPG, EPM, EPS 125-400 EPS-GOLD 250-400 ES, ES-II 125-400 ESG, ESC 125-400

Jandy Heater Rod Flame Sense LX LT LoNOx Kit R0387000 Used on the following models: LX/LT Low NOx all

LXi Heater Wire Harness Set Complete made by Jandy R0457600 Used on the following models: LXi 250, 300, 400

Jandy Heater Ceramic Insulator Assembly R0099300 Used on the following models: ESG 125 THRU 400

Jandy Heater Blower Pressure Switch R0456400 Used on the following LXi models: 250, 300, 400 The images below give instructions for replacing the ignition control, power distribution circuit board, universal controller power interface PCB and blower pressure switch in all Jandy LXi swimming pool/spa heaters. The instructions must be followed exactly. These instructions were written with safety as the priority. Not following the written procedure or taking short cuts may increase the risk of personal injury. Read through the instructions completely before starting the procedure(click on the images to enlarge them). Page 1 Page 2 Page 3 Page 4