Jandy Heater Pressure Switch 1-10 PSI R0015500 Used on the following models: Lite2 LD, LG (all models) Lite2 LJ (all models) Legacy Model LRZM Pool/Spa Heater (all models)

Pool Heater Ceramic Insulator made by Jandy R0011600 Used on the following models: EC, EPC 125-400 EPS, EPCII 125-400 ESC 125-400 ES, ESII 125-400

Jandy Heater Fitting For Syphon Loop Tube Heater Connect F0060700 Used on the following models: All LX / LT

LXi Low NOx Heater Flame Sensor Rod made by Jandy R0458600

Jandy Heater By-Pass Valve Disk R0011500 Used on the following models: EC, EG 125 THRU 400 EPC, EPC-|| 125 THRU 400 EPG, ESG, ESC 125 THRU 400 EPM, EPS 125 THRU 400E EPH 300 EPS GOLD 250 THRU 400 ES, ES-|| 125 THRU 400

Jandy Ignition Control Hot Surface LXi Replacement Kit R0456900 Used on the following LXi models: 250, 300, 400 The images below give instructions for replacing the ignition control, power distribution circuit board, universal controller power interface PCB and blower pressure switch in all Jandy LXi swimming pool/spa heaters. The instructions must be followed exactly. These instructions were written with safety as the priority. Not following the written procedure or taking short cuts may increase the risk of personal injury. Read through the instructions completely before starting the procedure (click on the images to enlarge them). Page 1 Page 2 Page 3 Page 4

Jandy Heater Fuse 1.25 AMP R0012300

Pool Heater Wire Harness made by Jandy R0058000 Used on the following models: EG, EPG 125-400 EPM 125-400 EPC LP 125-400 EPC II-LP 125-400

Jandy Heater Temperature Sensor R0011800 With Sleeve & Gasket. Used on the following models: LX / LT Low NOx (all models) LX / LT (all models) Hi-E2 (all models) Lite2 LD, LG (all models)

LXi Low NOx Water Pressure Switch made by Polaris R0457000 Used on the following models: LXi 250.000 BTU LXi 300.000 BTU LXi 400.000 BTU