Aqua-Flo A-Series Pump Volute 92770060

Aqua Flo A Series Pump Diagram PRIMING PUMP At initial start-up, pump must be primed by filling hair and lint trap with water. To prime pump, remove cover from hair and lint trap: fill pump and suction trap with water. Replace cover (make sure the o-ring is in place) and tighten lock handles. Pump will now prime, with priming time depending upon lift and horizontal distance of suction piping. CAUTION: Do not remove hair and lint strainer lid while pump is running or under pressure! Lid is held in place by lock handles which can be removed or tightened by hand. Basket must be kept clear of leaves and debris at all times. REMOVING BASKET Turn off motor. Remove lid. Remove basket and empty debris. Replace basket, fill with water, replace lid securely to prevent air from entering and tighten. DO NOT USE TOOLS. Turn on motor. Open air-relief valve on top of filter until steady stream of water comes out. NOTE: If pump is installed below water level of swimming pool, close return and suction lines prior to opening hair and lint pot. Make sure to re-open valves prior to operating. DO NOT RUN PUMP DRY! Always maintain proper
…read more